Research and implement of embedded wireless mobile communication system
|更新时间:2024-10-14
|
Research and implement of embedded wireless mobile communication system
Issue 1, Pages: 121-124(2008)
作者机构:
1. 中南民族大学计算机科学学院
2. 内蒙古工业大学信息工程学院
3. 杰脉通信技术有限公司
作者简介:
基金信息:
DOI:
CLC:TN929.5
Published:2008
稿件说明:
移动端阅览
TONG Xiao-nian1, AN Xing-ya2, LAN Xiao-pang3, et al. Research and implement of embedded wireless mobile communication system[J]. 2008, (1): 121-124.
DOI:
TONG Xiao-nian1, AN Xing-ya2, LAN Xiao-pang3, et al. Research and implement of embedded wireless mobile communication system[J]. 2008, (1): 121-124.DOI:
Research and implement of embedded wireless mobile communication system
摘要
为降低嵌入式无线移动通信系统的硬件开销和高效地开发嵌入式网络协议
构建了基于8位低端微控制器的嵌入式无线移动通信终端
同时根据软件工程原理
在系统实现中提出了以框架设计模式开发嵌入式网络协议的思想
实现了一个生成网络协议的通用框架
它采用UML状态机技术
将嵌入式网络协议的UML状态图转换为网络协议的实现代码。实验结果表明
该系统不仅极大地降低了对硬件资源的需求
UML状态机技术也为嵌入式系统软件的开发带来了规范性和高效率。
Abstract
In order to reduce hardware cost of embedded wireless mobile communication system and improve developing efficiency of embedded network protocol
the embedded wireless mobile communication terminal based on 8-bit basic MCU was proposed. Furthermore
according to software engineering principle
the general frame was designed to gener- ate embedded network protocol by UML state machine technology. The frame converted UML state figure into imple- menting codes of embedded network protocol. The experiment result shows that embedded wireless mobile communica- tion system not only reduces hardware expense but also incarnates standard and efficiency for development of embedded system software by UML state machine technology.